Installing and activating internal code changes

Install and activate retrieved internal code changes to make them operational.

Important:

Instructions for installing and activating internal code changes will vary with the set of changes you want to install, whether you want to activate them immediately, and how you want to activate them. Each example below provides instructions for a particular situation. Your situation may be different; refer to the instructions for general guidance. Then, while performing the task, request help for any window while it displays for more information about using it to complete the task.

Example 1

The following example shows the steps for:

• Installing all retrieved internal code changes.
• Activating the changes immediately and concurrently.

From the Hardware Management Console Workplace:
1. Select the target CPCs or CPC group, and start the task: Change Internal Code.

   This opens the Change Internal Code window. From the Change Internal Code window:

2. Select Install and activate changes that were retrieved, then select OK.

   This opens the Request Selection window. From the Request Selection window:

3. Select Do all concurrent changes only, then select Install and activate.

   This opens the Confirm the Action window. From the Confirm the Action window:

4. Select Install and activate concurrently to begin the process.

   This opens the Change Internal Code Progress window. From the Change Internal Code Progress window:

5. Wait until the window indicates the process is complete, then select OK to close the window.

   This completes the task.

Example 2

The following example shows the steps for:

• Installing all retrieved internal code changes.
• Activating the change immediately and disruptively.

From the Hardware Management Console Workplace:
1. Select the target CPCs or CPC group, and start the task: Change Internal Code.

   This opens the Change Internal Code window. From the Change Internal Code window:

2. Select Install and activate changes that were retrieved, then select OK.

   This opens the Request Selection window. From the Request Selection window:

3. Select Do all changes even if they are disruptive, then select Install and activate.

   This opens the Confirm this Disruptive Action window. From the Confirm this Disruptive Action window:

4. Select Install and activate disruptively to begin the process.

   This opens the Change Internal Code Progress window. From the Change Internal Code Progress window:

5. Wait until the window indicates the process is complete, then select OK to close the window.

   This completes the task.